How to remove and install the Fuel Pump Driver Module (FPDM) on Ford Crown Victoria?

The fuel pump driver is an external Fuel Pump Driver Module near the trunk. Remove the parcel shelf trim panel retainers, disconnect the FPDM connector, and remove the bolts and FPDM. Install it by reversing the removal steps. Make sure all bolts are tightened.

Genuine Ford Crown Victoria Fuel Pump Driver Module

Enter your vehicle info to find more parts and verify fitment

Select Vehicle by VIN
Select Vehicle by Model

Select by VIN

Enter your VIN for the most accurate results.

Select by Model

-- Select Make --

-- Select Model --

-- Select Year --

2 Fuel Pump Driver Modules found

View related parts
Ford Crown Victoria Module - Engine Fuel
Part Number: 6W7Z-9D372-CA
- Other Name: Fuel Pump Controller, Module
- Manufacturer Note: FROM 12-05-05
$151.62 MSRP: $221.67
You Save: $70.05 (32%)

Add to Cart
More Info
Fits the following Vehicles:
2006-2011 Ford Crown Victoria | 8 Cyl 4.6L, 8 Cyl 4.6L Romeo SOHC EFI | 4AT, 4AT 4R75W, 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
Less Info
View related parts
Ford Crown Victoria Module - Engine Fuel
Part Number: 3W1Z-9D372-AA
- Other Name: Module
More Info
Fits the following Vehicles:
2003-2005 Ford Crown Victoria | 8 Cyl 4.6L | 4AT, 4AT 4R70W, 4AT 4R75W
Less Info

Ford Crown Victoria Fuel Pump Driver Module Parts Questions & Answers

Module - Engine Fuel
6W7Z-9D372-CA
Q: How to remove and install the Fuel Pump Driver Module (FPDM) on Ford Crown Victoria?
A: The fuel pump driver is an external Fuel Pump Driver Module near the trunk. Remove the parcel shelf trim panel retainers, disconnect the FPDM connector, and remove the bolts and FPDM. Install it by reversing the removal steps. Make sure all bolts are tightened.