Genuine Ford F-150 CV Boot

Ford F-150 CV Boot Parts Questions & Answers

• Boot
  7L1Z-3A331-A
  Q: How to Check the Shock Absorber and CV Boot on Your Ford F-150?

  A: Regular checks of the steering linkage and suspension are vital for vehicle performance and safety. Worn or damaged components can cause tire wear, poor handling, and reduced fuel economy. To assess shock absorbers, park on level ground, turn off the engine, and set the parking brake. Check tire pressures and push down on each corner, observing movement and rebound. Proper shock absorbers should bring the vehicle to rest in a level position within one or two bounces. Inspect for fluid leakage and secure mounting. Visually examine steering and suspension components for damage, leaks, and loose bushings. Check the steering system for movement at the knuckle-to-control arm balljoint. Test for play in the steering system components. Regularly inspect CV boots for tears, cracks, and loose clamps. Clean CV Boot to prevent deterioration and replace if damaged.
• Boot
  2L1Z-3A331-AA
  Q: How to replace the CV Boot on Ford F-150?

  A: First, it is important to check the condition of the CV joints before disassembling and inspecting the CV joints and CV Boot. If wear is indicated by torn boots, rebuilt drive axles should be considered. To continue with disassembly, remove the drive axle, cut off the boot clamps, and slide back the boot. Remove the wire ring ball retainer then the outer race and clean the inner bearing. Taking off the snap ring results in the sliding of the inner bearing assembly, which leads to an inspection of the race cage and inner race lands. Components should be cleaned thoroughly after this. After that reassemble the inner race into the cage by pressing balls into cage windows then reassemble the joint again Reinstall a new boot clamp then add a boot Fill the outer race with CV joint grease; pack the inner race and cage assembly with grease; slide outer race over inner race Lastly install CV Boot and clamps if required adjust drive axle length.