×
- Live Chat
- 1-888-788-9341
My Garage
My Account
Cart
Genuine Ford Fairmont Spark Plug
Ignition Spark Plug- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Spark Plug found
Ford Fairmont Spark Plug
It is an important component in the evaluation of combustion because it produces a needed spark in Ford Fairmont vehicles. This component contains electrodes which are made of metal and thus has another metal terminal and it also has a ceramic insulator which altogether is enclosed in a steel armour. TS: Copper core, platinum and iridium Spark Plugs are available in the market with differences in the durability and performance. The ignition coil produces the high voltage required for the Spark Plug to produce a spark to in turn power the engine. Ford Fairmont vehicles require consistent servicing of and changes to Spark Plugs to maintain high performance; fuel effeciency.
We provide a wide range of Ford Fairmont Spark Plug at the best prices possible. If you need Ford Fairmont Spark Plug, you can shop with confidence on our website. All our OEM parts come with a manufacturer's warranty and are delivered to your door step with a fast delivery service.
Ford Fairmont Spark Plug Parts Questions & Experts Answers
- Q: How to remove and install spark plug on Ford Fairmont?A: Before removing any spark plug wires, ensure they are properly numbered as to their original location. Mark the wires with tape if necessary or remove only one plug at a time so that the wires are always in order. Remove each spark plug wire by grasping the molded boot, twisting it slightly and then pulling it away from the end of the spark plug. Do not pull on the wire itself because it could separate the connector inside the boot. If this happens, the wire must be replaced with a new one. Using an insulated spark plug socket, loosen each spark plug about two turns and carefully clean around the plug hole so that no dirt can enter when the plug is removed. Fully remove each of the spark plugs by hand. Inspect the firing ends of the plugs for deposits and electrode condition. Inspect the insulators for cracks and discoloration. If the plug appears usable, clean it with a wire brush to remove carbon deposits from the electrodes and threads. Use a small file to clean the electrode surfaces. Set the spark plug electrode gap to the setting on the emission control decal by bending the outer electrode, never the center one. Position each plug into its cylinder head port and thread into the hole by hand. Fully tighten each of the plugs to the proper torque. Using a clean standard screwdriver, apply a thin film of silicone grease on the entire interior surface of the spark plug wire boot. Push each of the spark plug wires into position on the ends of the plugs, again using a twisting motion to fully seat the boots. Make sure that the wires are re-installed in their original positions. Uncover or re-connect the battery.
