How to disconnect the negative battery cable and remove the blower motor in a Ford Thunderbird?

To disconnect the negative battery cable, squeeze the glove compartment sides to lower the door. Through the opening, unplug the blower motor by pressing the locking tabs and removing the connector. Unscrew the motor from the housing and remove it with the mounting plate, and, if replacing the motor, remove the clip and fan from the shaft and attach to the new motor. Finally, reconnect the battery, test the blower, and reset the glove compartment door.

Genuine Ford Thunderbird Blower Motor

A/C Heater Blower Motor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

4 Blower Motors found

View related parts
Ford Thunderbird Motor - Cooling Blower
Part Number: F4SZ-19805-HA
Product Specifications
- Other Name: Blower Assembly, Blower Motor
- Manufacturer Note: Kit, includes motor, harness, seal & retainer
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1995-1997 Ford Thunderbird | 6 Cyl 3.8L, 8 Cyl 4.6L | 4AT 4R70W, 5MT
View related parts
Ford Thunderbird Motor - Cooling Blower
Part Number: F4ZZ-19805-C
Product Specifications
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1983-1989 Ford Thunderbird | 4 Cyl 2.3L, 6 Cyl 3.8L, 8 Cyl 5.0L | 3AT C3, 3AT C5, 4AT A4LD, 4AT AOD, 5MT
View related parts
Ford Thunderbird Motor - Cooling Blower
Part Number: F4SZ-19805-A
Product Specifications
- Manufacturer Note: Kit, includes motor, harness, seal & retainer
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1994 Ford Thunderbird | 6 Cyl 3.8L, 8 Cyl 4.6L | 4AT 4R70W, 5MT
- 1989 Ford Thunderbird | 6 Cyl 3.8L | 4AT AOD, 5MT
View related parts
Ford Thunderbird Motor - Cooling Blower
Part Number: XW4Z-19805-EA
Product Specifications
- Other Name: Blower Motor
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2002-2005 Ford Thunderbird | 8 Cyl 3.9L DOHC EFI NA | 5-Speed Automatic Transmission 5R55S, 5-Speed Automatic Transmission NAAO 5R55N, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)

Ford Thunderbird Blower Motor

The Blower Motor in Ford Thunderbird vehicles is among the indispensable components of the vehicle's HVAC system as it is in charge of regulating the speed to blow either hot or cool air in the car cabin. Located near the blower motor is the blower motor controls through which drivers can control the amount of air that is drawn into the system for quicker fixes of foggy windows or hot interiors. Usually wired with the blower motor control module, the blower motor controls are located deep inside the car but are relatively easy to access. However, in some cases, failure might be noticed in the electronic module or wiring that hampers the control over the heating and air conditioning system and thus the damaged part should be replaced without delay. When the blower motor control is failing, some of the signs that are visible maybe that the HVAC system lacks control to properly operate and then a closer look will be made to diagnose the problem.

We provide a wide range of Ford Thunderbird Blower Motor at the best prices possible. If you need Ford Thunderbird Blower Motor, you can shop with confidence on our website. All our OEM parts come with a manufacturer's warranty and are delivered to your door step with a fast delivery service.

Ford Thunderbird Blower Motor Parts Questions & Experts Answers

Motor - Cooling Blower
F4ZZ-19805-C
Q: How to disconnect the negative battery cable and remove the blower motor in a Ford Thunderbird?
A: To disconnect the negative battery cable, squeeze the glove compartment sides to lower the door. Through the opening, unplug the blower motor by pressing the locking tabs and removing the connector. Unscrew the motor from the housing and remove it with the mounting plate, and, if replacing the motor, remove the clip and fan from the shaft and attach to the new motor. Finally, reconnect the battery, test the blower, and reset the glove compartment door.