How to remove and replace the fuel filter on a Ford Thunderbird?

The fuel filter is located under the vehicle on the outside of the right frame rail. To remove it, take out the two retaining bolts, loosen the screw clamp and remove the filter cover. Inspect the hose fittings at both ends of the filter to see if they're clean. If more than a light coating of dust is present, clean the fittings before proceeding. Relieve the fuel system pressure. Removal of the hairpin clip from each fitting is a two-stage procedure. First, spread the two clip legs apart about 1/8-inch to disengage them, then push in on them. Pull on the other end of the clip to detach it from the fitting. If the new filter doesn't include new clips, don't use any tools or you may damage the plastic clips, which will have to be reused. Use your fingers only. Once both hairpin clips are released, grasp the fuel hoses, one at a time, and pull them straight off the filter. Be prepared for fuel spillage. After the hoses have been detached, check the clips for damage and distortion. If they were damaged in any way during removal, new ones must be used when the hoses are reattached to the new filter. Note which way the arrow on the filter is pointing- the new filter must be installed the same way. Install the new filter with the arrow pointing the right direction. Carefully push each hose onto the filter until it's seated against the collar on the fitting, then install the hairpin clips. The triangular shaped side of each clip must point away from the filter. Make sure the clips are securely attached to the hose fittings - if they come off, the hoses could back off the filter and a fire could result! Place the filter in the bracket and secure it with the screw clamp. Place the bracket and filter assembly in position and install the retaining bolts. Start the engine and check for fuel leaks.

Genuine Ford Thunderbird Fuel Filter

Gas Filter

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

8 Fuel Filters found

View related parts
Ford Thunderbird Filter Assembly - Fuel
Part Number: F89Z-9155-A
$16.63 MSRP: $31.82
You Save: $15.19 (48%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Filter Assy - Fuel
- Replaced by: 2M5Z-9155-CA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2002 Ford Thunderbird | 8 Cyl 3.9L DOHC EFI NA | 5-Speed Automatic Transmission NAAO 5R55N, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Thunderbird Filter Assembly - Fuel
Part Number: F1SZ-9155-A
$15.66 MSRP: $38.91
You Save: $23.25 (60%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Filter Assy - Fuel; Fuel Filter
- Manufacturer Note: FROM 11/90
- Replaces: F1SZ-9B072-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1991-1997 Ford Thunderbird | 6 Cyl 3.8L, 8 Cyl 4.6L, 8 Cyl 5.0L | 4AT 4R70W, 4AT AOD, 5MT
View related parts
Ford Thunderbird Filter Assembly - Fuel
Part Number: E9SZ-9155-A
$15.30 MSRP: $38.00
You Save: $22.70 (60%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Filter Assy - Fuel; Fuel Filter
- Manufacturer Note: BEFORE 11/90
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1989-1991 Ford Thunderbird | 6 Cyl 3.8L, 8 Cyl 5.0L | 4AT AOD, 5MT
View related parts
Ford Thunderbird Filter Assembly - Fuel
Part Number: E7DZ-9155-A
$21.09 MSRP: $33.64
You Save: $12.55 (38%)
ADD TO CART
Product Specifications
- Other Name: Filter Assy - Fuel
- Replaced by: YF1Z-9155-CA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1983-1988 Ford Thunderbird | 4 Cyl 2.3L, 6 Cyl 3.8L, 8 Cyl 5.0L | 3AT C3, 3AT C5, 4AT A4LD, 4AT AOD, 5MT
View related parts
Ford Thunderbird Filter Assembly - Fuel
Part Number: 2C5Z-9155-AA
$23.03 MSRP: $36.73
You Save: $13.70 (38%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Filter Assy - Fuel
- Manufacturer Note: 2 Ports
- Replaced by: 2C5Z-9155-BC
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2003-2005 Ford Thunderbird | 8 Cyl 3.9L DOHC EFI NA | 5-Speed Automatic Transmission 5R55S, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Thunderbird Filter Assembly - Fuel
Part Number: E3FZ-9155-F
$11.97 MSRP: $19.09
You Save: $7.12 (38%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Filter Assy - Fuel; Fuel Filter
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1981-1986 Ford Thunderbird | 4 Cyl 2.3L, 6 Cyl 3.3L, 6 Cyl 3.8L, 8 Cyl 4.2L, 8 Cyl 5.0L | 3AT C3, 3AT C4, 3AT C5, 4AT AOD, 5MT
View related parts
Ford Thunderbird Filter Assembly - Fuel
Part Number: D3AZ-9155-C
$8.47 MSRP: $13.51
You Save: $5.04 (38%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Filter Assy - Fuel; Fuel Filter
- Replaces: FG-14-D, D3AZ-9155-D
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1980-1982 Ford Thunderbird | 6 Cyl 3.3L, 6 Cyl 3.8L, 8 Cyl 4.2L, 8 Cyl 5.0L | 3AT C3, 3AT C4, 3AT C5, 4AT AOD
View related parts
Ford Thunderbird Filter Assembly - Fuel
Part Number: D3FZ-9155-B
Product Specifications
- Other Name: Filter Assy - Fuel
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1980 Ford Thunderbird | 6 Cyl 3.3L, 8 Cyl 4.2L, 8 Cyl 5.0L | 3AT C4, 4AT AOD

Ford Thunderbird Fuel Filter

The Fuel Filter used in Ford known as Ford Thunderbird is a specialty tool in the fuel system working as a guard to protect the engine from dirt, rust, and water which are destructive to the engine. With permeable paper used in the Fuel Filter, it is able to filter out abrasive particles that are detrimental to fuel pump and injectors hence enhancing the engine's performance and efficiency. Thus, maintaining the Fuel Filter should be frequently performed because the clogging of this component can affect the fuel flow and thus the efficiency of the engine. In diesel engines for example, accompanied filters can also remove and discharge water in order to protect the fuel system from such harms. In general, Ford Thunderbird vehicles greatly depend on the Fuel Filter to enhance the durability of its engine as well as its efficiency.

We provide a wide range of Ford Thunderbird Fuel Filter at the best prices possible. If you need Ford Thunderbird Fuel Filter, you can shop with confidence on our website. All our OEM parts come with a manufacturer's warranty and are delivered to your door step with a fast delivery service.

Ford Thunderbird Fuel Filter Parts Questions & Experts Answers

Filter Assembly - Fuel
E9SZ-9155-A
Q: How to remove and replace the fuel filter on a Ford Thunderbird?
A: The fuel filter is located under the vehicle on the outside of the right frame rail. To remove it, take out the two retaining bolts, loosen the screw clamp and remove the filter cover. Inspect the hose fittings at both ends of the filter to see if they're clean. If more than a light coating of dust is present, clean the fittings before proceeding. Relieve the fuel system pressure. Removal of the hairpin clip from each fitting is a two-stage procedure. First, spread the two clip legs apart about 1/8-inch to disengage them, then push in on them. Pull on the other end of the clip to detach it from the fitting. If the new filter doesn't include new clips, don't use any tools or you may damage the plastic clips, which will have to be reused. Use your fingers only. Once both hairpin clips are released, grasp the fuel hoses, one at a time, and pull them straight off the filter. Be prepared for fuel spillage. After the hoses have been detached, check the clips for damage and distortion. If they were damaged in any way during removal, new ones must be used when the hoses are reattached to the new filter. Note which way the arrow on the filter is pointing- the new filter must be installed the same way. Install the new filter with the arrow pointing the right direction. Carefully push each hose onto the filter until it's seated against the collar on the fitting, then install the hairpin clips. The triangular shaped side of each clip must point away from the filter. Make sure the clips are securely attached to the hose fittings - if they come off, the hoses could back off the filter and a fire could result! Place the filter in the bracket and secure it with the screw clamp. Place the bracket and filter assembly in position and install the retaining bolts. Start the engine and check for fuel leaks.