What precautions should be taken when performing repairs to the fuel tank or filler neck on Mercury Grand Marquis?

In all cases, repairs to the fuel tank or filler neck should be done by a professional who has undergone the appropriate training to carry out this crucial and potentially harmful task. Explosive fumes may still be present even after the tank has been cleaned and flushed and they could explode when it is being repaired. If the fuel tank is taken out of the vehicle, it should never be put in a place where sparks or open flames can ignite the fumes coming out from it.

How to remove and install a fuel tank on Mercury Grand Marquis?

Don't begin this procedure until the gauge indicates that the tank is empty or nearly empty. If the tank must be removed when it's full, for example, if the fuel pump malfunctions, siphon any remaining fuel from the tank prior to removal. Unless the vehicle has been driven far enough to completely empty the tank, it's a good idea to siphon the residual fuel out before removing the tank from the vehicle. Warning: DO NOT start the siphoning action by mouth! Use a siphoning kit, available at most auto parts stores. Relieve the fuel pressure. Detach the cable from the negative terminal of the battery. Raise the vehicle and support it securely on jackstands. Remove the fuel tank filler neck bracket bolts securing the fuel filler neck and the fuel tank filler pipe retainer and slide the assembly from the vehicle. Disconnect the fuel lines and vapor lines. Remove the electric fuel pump and sending unit electrical connector with a screwdriver. Place a floor jack under the tank and position a block of wood between the jack pad and the tank. Raise the jack until it's supporting the tank. Remove the bolts or nuts from the front ends of the fuel tank straps. The straps are hinged at the other end so you can swing them out of the way. Lower the tank far enough to unplug any vapor lines or wire harness brackets that may be difficult to reach when the fuel tank is in the vehicle. Slowly lower the jack while steadying the tank. Remove the tank from the vehicle. Remove and install the fuel pump/sending unit. Installation is the reverse of removal. SAE 10W-40 engine oil can be used as an assembly aid when pushing the fuel filler neck back into the tank.

Genuine Mercury Grand Marquis Fuel Tank

Gas Tank

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

11 Fuel Tanks found

View related parts
Mercury Grand Marquis Fuel Tank Assembly
Part Number: 1W1Z-9002-AC
Product Specifications
- Other Name: Tank Assembly - Fuel
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2001-2002 Mercury Grand Marquis | 8 Cyl 4.6L | 4AT 4R70W
View related parts
Mercury Grand Marquis Fuel Tank Assembly
Part Number: 3W1Z-9002-AA
Product Specifications
- Other Name: Tank Assembly - Fuel
- Manufacturer Note: Less NGV
- Replaced by: BW1Z-9002-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2003-2004 Mercury Grand Marquis | 8 Cyl 4.6L | 4AT 4R70W
View related parts
Mercury Grand Marquis Fuel Tank Assembly
Part Number: 5W1Z-9002-AA
Product Specifications
- Other Name: Tank Assembly - Fuel
- Manufacturer Note: Has push in type pressure valve., FROM 2/15/2005
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2005 Mercury Grand Marquis | 8 Cyl 4.6L | 4AT 4R70W
View related parts
Mercury Grand Marquis Fuel Tank Assembly
Part Number: 5W1Z-9002-AB
Product Specifications
- Other Name: Tank Assembly - Fuel
- Manufacturer Note: HAS CAM-LOCK AND TWIST PRESSURE VALVE., BEFORE 2/15/2005
- Replaced by: BW1Z-9002-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2005 Mercury Grand Marquis | 8 Cyl 4.6L | 4AT 4R70W
View related parts
Mercury Grand Marquis Fuel Tank Assembly
Part Number: 6W1Z-9002-AA
Product Specifications
- Other Name: Tank Assembly - Fuel
- Manufacturer Note: Has push in type pressure valve., FFV (Ethanol) Fuel, FROM 2/15/2005
- Replaced by: BW1Z-9002-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2006 Mercury Grand Marquis | 8 Cyl 4.6L | 4AT 4R70W
View related parts
Mercury Grand Marquis Fuel Tank Assembly
Part Number: 6W1Z-9002-B
Product Specifications
- Other Name: Tank Assembly - Fuel
- Manufacturer Note: Has push in type pressure valve., All non Flex Fuel Capability, FROM 2/15/2005
- Replaced by: BW1Z-9002-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2006 Mercury Grand Marquis | 8 Cyl 4.6L | 4AT 4R70W
View related parts
Mercury Grand Marquis Fuel Tank Assembly
Part Number: 7W1Z-9002-A
Product Specifications
- Other Name: Tank Assembly - Fuel
- Replaced by: BW1Z-9002-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2008 Mercury Grand Marquis | 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Mercury Grand Marquis Fuel Tank Assembly
Part Number: 8W1Z-9002-A
$0.00
Product Specifications
- Other Name: Tank Assembly - Fuel
- Replaced by: BW1Z-9002-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2008 Mercury Grand Marquis | 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Mercury Grand Marquis Fuel Tank Assembly
Part Number: 9W1Z-9002-A
Product Specifications
- Other Name: Tank Assembly - Fuel
- Replaced by: BW1Z-9002-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2009-2011 Mercury Grand Marquis | 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Mercury Grand Marquis Fuel Tank Assembly
Part Number: F8AZ-9002-BD
Product Specifications
- Other Name: Tank Assembly - Fuel
- Manufacturer Note: BEFORE 5/27/99
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1998-1999 Mercury Grand Marquis | 8 Cyl 4.6L | 4AT 4R70W
View related parts
Mercury Grand Marquis Fuel Tank Assembly
Part Number: XW7Z-9002-AA
Product Specifications
- Other Name: Tank Assembly - Fuel; Fuel Tank
- Manufacturer Note: FROM 5/27/99
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1998-2000 Mercury Grand Marquis | 8 Cyl 4.6L | 4AT 4R70W

Mercury Grand Marquis Fuel Tank

Fuel Tank or main tank in mercury grand marquis is a storage tank for fuel which contain electric fuel pump and fuel gauge sender. It has baffles to minimized fuel swirling or splashing, is part of the Evaporative Emission Control System and may be metallic or plastic in construction. Metal tanks are stamped and welded while on the other end, plastic tanks are blow molded. Used fuel tanks can be attacked by corrosion, impact forces, and fluctuations in temperatures. Fuel cells in racing cars are built in such a way that when the car is wrecked gas does not spill out. With a storage capacity of up to 50 gallons, fuel tanks built from military grade poly mineral can increase the driving distance by upto 500 miles providing a corrosion proof solution to the more conventional steel tanks.

We provide a wide range of Mercury Grand Marquis Fuel Tank at the best prices possible. If you need Mercury Grand Marquis Fuel Tank, you can shop with confidence on our website. All our OEM parts come with a manufacturer's warranty and are delivered to your door step with a fast delivery service.

Mercury Grand Marquis Fuel Tank Parts Questions & Experts Answers

Fuel Tank Assembly
7W1Z-9002-A
Q: What precautions should be taken when performing repairs to the fuel tank or filler neck on Mercury Grand Marquis?
A: In all cases, repairs to the fuel tank or filler neck should be done by a professional who has undergone the appropriate training to carry out this crucial and potentially harmful task. Explosive fumes may still be present even after the tank has been cleaned and flushed and they could explode when it is being repaired. If the fuel tank is taken out of the vehicle, it should never be put in a place where sparks or open flames can ignite the fumes coming out from it.
Fuel Tank Assembly
6W1Z-9002-AA
Q: How to remove and install a fuel tank on Mercury Grand Marquis?
A: Don't begin this procedure until the gauge indicates that the tank is empty or nearly empty. If the tank must be removed when it's full, for example, if the Fuel Pump malfunctions, siphon any remaining fuel from the tank prior to removal. Unless the vehicle has been driven far enough to completely empty the tank, it's a good idea to siphon the residual fuel out before removing the tank from the vehicle. Warning: DO NOT start the siphoning action by mouth! Use a siphoning kit, available at most auto parts stores. Relieve the fuel pressure. Detach the cable from the negative terminal of the battery. Raise the vehicle and support it securely on jackstands. Remove the fuel tank filler neck bracket bolts securing the fuel filler neck and the fuel tank filler pipe retainer and slide the assembly from the vehicle. Disconnect the fuel lines and vapor lines. Remove the electric fuel pump and sending unit electrical connector with a screwdriver. Place a floor jack under the tank and position a block of wood between the jack pad and the tank. Raise the jack until it's supporting the tank. Remove the bolts or nuts from the front ends of the fuel tank straps. The straps are hinged at the other end so you can swing them out of the way. Lower the tank far enough to unplug any vapor lines or wire harness brackets that may be difficult to reach when the fuel tank is in the vehicle. Slowly lower the jack while steadying the tank. Remove the tank from the vehicle. Remove and install the fuel pump/sending unit. Installation is the reverse of removal. SAE 10W-40 engine oil can be used as an assembly aid when pushing the fuel filler neck back into the tank.

Related Mercury Grand Marquis Parts

Browse by Year

2011 Fuel Tank 2010 Fuel Tank 2009 Fuel Tank 2008 Fuel Tank 2007 Fuel Tank 2006 Fuel Tank 2005 Fuel Tank 2004 Fuel Tank 2003 Fuel Tank 2002 Fuel Tank 2001 Fuel Tank 2000 Fuel Tank 1999 Fuel Tank 1998 Fuel Tank