Ford 7L1Z-3085-A Arm Assembly - Front Suspension

You can Select Your Vehicle to check if 7L1Z-3085-A fits your vehicle.

The front suspension includes a stabilizer bar, which reduces vehicle roll during cornering, and a steering linkage comprising a Pitman arm, idler arm, center link, and adjustable tie-rod assemblies. These components allow for steering force transfer and toe-in adjustments.

Measure the height of the center of the hub to the ground before proceeding. These measurements help ensure proper alignment and suspension adjustment. Additionally, you should loosen the wheel lug nuts and raise the front of the vehicle while securely supporting it on jackstands. Remove the wheel.

Spray penetration oil around the flange and studs if it's stuck due to corrosion. If it's locked onto the shoes due to excessive wear, remove the plug in the access hole and back off the adjuster wheel.

Remove the wheel.

Yes, warnings about specific procedures are mentioned.

Yes, this procedure applies to both 2WD and 4WD models.

When dealing with stubborn fasteners due to rust or corrosion, use penetrating oil, wire brushes, and caution. Strategies like applying a sharp blow with a hammer, heating the fastener area, or using breaker bars can help. However, exercise caution to prevent thread damage or fire hazards. Replace difficult-to-unscrew fasteners with new ones. For safety, use reliable jackstands and prefer a hydraulic floor jack for lifting and supporting components during various operations.

The first step is to loosen the wheel lug nuts and raise the front of the vehicle, supporting it securely on jackstands.