Ford 9L3Z-3084-A Arm Assembly - Front Suspension

You can Select Your Vehicle to check if 9L3Z-3084-A fits your vehicle.

When dealing with stubborn fasteners due to rust or corrosion, use penetrating oil, wire brushes, and caution. Strategies like applying a sharp blow with a hammer, heating the fastener area, or using breaker bars can help. However, exercise caution to prevent thread damage or fire hazards. Replace difficult-to-unscrew fasteners with new ones. For safety, use reliable jackstands and prefer a hydraulic floor jack for lifting and supporting components during various operations.

Yes, there are procedures provided for lower control arms, upper control arms, toe link rods, trailing arms (on 2007 and later models), and stabilizer bars.

Measure the height of the center of the hub to the ground before proceeding. These measurements help ensure proper alignment and suspension adjustment. Additionally, you should loosen the wheel lug nuts and raise the front of the vehicle while securely supporting it on jackstands. Remove the wheel.

The front suspension includes a stabilizer bar, which reduces vehicle roll during cornering, and a steering linkage comprising a Pitman arm, idler arm, center link, and adjustable tie-rod assemblies. These components allow for steering force transfer and toe-in adjustments.

Yes, there are procedures provided for lower control arms, upper control arms, toe link rods, trailing arms (on 2007 and later models), and stabilizer bars.

If the vehicle is equipped with air suspension, you should turn off the air suspension system, and the switch for this is located in the area of the right kick panel.

After raising the vehicle, apply the parking brake and remove the wheel.

Apply the parking brake.