Ford F6TZ-7000-DARM Automatic Transmission Assembly

You can Select Your Vehicle to check if F6TZ-7000-DARM fits your vehicle.

The initial steps for removing the transmission are as follows:1. Disconnect the battery negative cable.2. Drain the transmission lubricant into a suitable container.

The E4OD 4-speed transmission was introduced in 1988.

To remove the transmission, follow these steps:1. Disconnect the cable from the negative battery terminal.2. Raise the vehicle on a hoist or with jack stands for better access.3. Drain the transmission fluid and temporarily install the pan.4. Remove the torque converter access cover and adapter plate bolts.5. Take off the driveplate-to-converter attaching nuts, making sure to mark their relationship to the driveplate.6. Rotate the engine to access the converter drain plug and remove it.7. On 2WD models, remove the driveshaft and cover the transmission end. On 4WD models, remove the transfer case.8. Detach the speedometer cable on pre-1992 2WD models.9. Remove the manual shift linkage, TV control rod or cable, kickdown rod or cable, and vacuum modulator hose if equipped.10. Disconnect the neutral safety switch electrical connector, manual lever position sensor electrical connector (E4OD only), and solenoid body electrical connector (E4OD only).11. Remove the transmission fluid filler tube and dipstick.

The E4OD transmission is a fully automatic, electronically controlled, four-speed unit with a locking torque converter.

Overhauling a manual transmission is a challenging task that involves disassembling and reassembling numerous small parts. Precise measurements of clearances must be taken, and select fit spacers and snap-rings may need to be changed.

The 3-speed model is a side shifter with external shift levers and mechanism, allowing the use of a steering column shift lever. The remaining transmissions contain the shift mechanisms internally, allowing direct-shifting from a simple top-mounted shift lever which extends through the floor of the cab.