Ford F6TZ-7000-HARM Automatic Transmission Assembly

You can Select Your Vehicle to check if F6TZ-7000-HARM fits your vehicle.

To remove the transmission, follow these steps:1. Disconnect the cable from the negative battery terminal.2. Raise the vehicle on a hoist or with jack stands for better access.3. Drain the transmission fluid and temporarily install the pan.4. Remove the torque converter access cover and adapter plate bolts.5. Take off the driveplate-to-converter attaching nuts, making sure to mark their relationship to the driveplate.6. Rotate the engine to access the converter drain plug and remove it.7. On 2WD models, remove the driveshaft and cover the transmission end. On 4WD models, remove the transfer case.8. Detach the speedometer cable on pre-1992 2WD models.9. Remove the manual shift linkage, TV control rod or cable, kickdown rod or cable, and vacuum modulator hose if equipped.10. Disconnect the neutral safety switch electrical connector, manual lever position sensor electrical connector (E4OD only), and solenoid body electrical connector (E4OD only).11. Remove the transmission fluid filler tube and dipstick.

The E4OD transmission is a fully automatic, electronically controlled, four-speed unit with a locking torque converter.

The application of the transmissions depends on the year, engine, and model of the vehicle in which it is installed. If unsure, it's recommended to check with a local Ford dealer or automotive transmission facility.

Before reinstalling the transmission, it is important to rotate the input shaft and shift the case through its gears to check for any binding, excessive resistance, or lock-up. Any abnormal behavior should be resolved before applying engine power to prevent further damage.

If cost is a concern, replacing the faulty transmission with a new or rebuilt unit may be an option.

After the transmission is removed, you should check all clutch-related components and replace worn parts as required. Additionally, prepare the release bearing for reinstallation and install the clutch housing if removed.