Ford AA8Z-5A772-C Bar - Stabilizer

You can Select Your Vehicle to check if AA8Z-5A772-C fits your vehicle.

Loosen the rear wheel lug nuts, raise the rear of the vehicle, and support it securely on jackstands, then remove the wheels. Support the exhaust system with a floor jack, detach the two rear exhaust system hangers from their anchors, and lower the exhaust system about two inches. Remove the nuts and detach the stabilizer bar links from the bar, then remove the stabilizer bar bracket bolts and the bar itself. Inspect the bushings while the stabilizer bar is off the vehicle and replace the stabilizer bar if the bushings are cracked, worn, or deteriorated. Installation is the reverse of removal, tightening the fasteners to the specified torque values. Install the wheel and lug nuts, then lower the vehicle and tighten the lug nuts to the torque.

Place the shifter in the Neutral position. Detach the oxygen sensor harness from the rear of the subframe, then disconnect the electrical connector. If you're working on an all-wheel drive model, remove the exhaust Y pipe and the front catalytic converter. If you're working on a 2007 or earlier model, remove the rear catalytic converter.