Ford F7ZZ-7548-AA Bearing Assembly - Clutch Release

You can Select Your Vehicle to check if F7ZZ-7548-AA fits your vehicle.

These components are said to be removed by; The negative cable from the battery is disconnected then the transmission is accompanied by the bellhousing. Finally, remove the clutch release lever away from the ball stud and, in the same manner remove the bearing from the lever. Place one hand on the outer ring and apply pressure with the other; try to turn the bearing-if it does not turn smoothly or is squeaky, replace it. Clean the bearing and inspect it for any signs of damage, wear and crack, while it is designed to be more or less sealed for life. Before fitting, it is necessary to lubricate the clutch lever crown and spring retention crown with lithium base grease at points they engage the bearing and pushing the bearing together the lithium base grease from the inner groove of the bearing. Fitting of release bearing should be done to the clutch lever after which high-temperature grease should be applied on the clutch release lever ball socket and pulled over the ball stud until firmly in place. Light coat of high temperature grease shall be applied to the face of the release bearing, contacting with the pressure plate diaphragm fingers. The bellhousing must be placed on the engine and the bolts ought to be tightened to the desired moment. Before putting the transmission, some light coat of grease must be applied on the front bearing retainer, in putting the completed assembly, the steps in the removal must be followed, just that all bolts must be tightened to the required torque.