Ford E3MZ-9A820-A Control Cable Assembly

You can Select Your Vehicle to check if E3MZ-9A820-A fits your vehicle.

On later models, the speedometer is electric, with a signal provided by the Vehicle Speed Sensor (VSS). On these models there is no mechanical speedometer cable. Disconnect the cable from the negative battery terminal. Disconnect the speedometer cable from the transmission or cruise control speed sensor adapter. Models with cruise control adapters have two speedometer cables: one between the transmission and the adapter and one leading from the adapter to the speedometer housing. Detach the cable from the routing clips in the engine compartment and pull the cable up to provide enough slack to allow disconnection from the speedometer. Remove the instrument cluster screws, pull the cluster out, then reach behind it and disconnect the speedometer cable from the back of the cluster by pressing on the cable release clip. Remove the cable from the vehicle. Prior to installation, press a 3/16-inch ball of silicone or equivalent lubricant Into the speedometer opening. Installation is the reverse of removal.

On the later models the speedometer is electrical, a signal being sent to it by the Vehicle Speed Sensor(VSS), this does away with the mechanical speedometer cable. The first step is to unplug the cable from the negative terminal of the battery then follow it up by removing the speedometer cable from the transmission system or the cruise control adapter. Proceeding with the installation, it is necessary to take out the cable from the routing clips in the engine compartment and pull it upward to gain the necessary amount of free length for the disconnection of the speedometer. Next remove the screws holding the instrument cluster, remove the cluster and releasing the speedometer cable from back of the cluster by pressing on its cable release tab. Therefore, after the removal of the cable from the vehicle it is recommended to apply a lump of silicone of 3/16 inch into the speedometer opening and reversing the process of removal to apply the cable.