Ford C6TZ-14526-AB Circuit Breaker Assembly

You can Select Your Vehicle to check if C6TZ-14526-AB fits your vehicle.

If an electrical component fails, always check the fuse first.

A blown fuse can be identified if power is present at one side of the fuse but not the other, or by visually inspecting it.

Disconnect the battery negative cable before replacing high current fuses. The manufacturer recommends that high capacity fuses be replaced by a dealer or qualified electrical technician.

A blown fuse can be confirmed visually by inspecting it.

The electrical circuits of the vehicle are protected by a combination of fuses, circuit breakers, and cartridge-type fusible links.

Two types of fuses are used, depending on the date of manufacture. Early models use a glass tube design, while later models use miniaturized fuses with a blade terminal design.

When replacing blown fuses, it is important to replace them with the correct type. Fuses of different ratings are physically interchangeable, but only fuses of the proper rating should be used.

If the replacement fuse immediately fails, don't replace it again until the cause of the problem is isolated and corrected. In most cases, the cause will be a short circuit in the wiring caused by a broken or deteriorated wire.

The electrical circuits of the vehicle are protected by a combination of fuses, circuit breakers, and fusible links.

The underhood power center is located next to the battery in the engine compartment and contains relays and high-amperage fuses.

To replace a fuse, first turn the ignition switch OFF. Grasp the push-in type fuse with the provided tool, or a pair of needle-nose pliers. Look through the side of the fuse body to determine if the fuse element is blown. Check the amperage rating of the fuse which was removed and obtain a new fuse of the same rating. Align the fuse with its mounting position and push it into place until fully seated in the panel. Turn the ignition switch on and operate the accessory that was protected by that fuse.

The protected circuit is identified on the face of the fuse panel cover above each fuse.

These compact fuses allow fingertip removal and replacement.

The power distribution box is located in the engine compartment on the left inner fenderwell and contains miniaturized fuses, cartridge-type fusible links, relays, and circuit breakers.

Each electrical circuit needs a specific amount of protection. Using a fuse with a higher or lower value than specified is not recommended.