Ford 4L2Z-3A130-AA End - Spindle Rod Connecting

You can Select Your Vehicle to check if 4L2Z-3A130-AA fits your vehicle.

To remove the front wheel, first loosen the lug nuts on the side to be dismantled, then raise the vehicle and support it securely on jackstands. If the vehicle has Automatic Ride Control, ensure the air suspension switch is turned off before raising the vehicle to avoid damage. Next, remove the front wheel, then take out the cotter pin and loosen the nut on the tie-rod end stud, discarding the cotter pin afterward. Use a Pitman arm puller to disconnect the tie-rod from the steering spindle, ensuring to back off the nut without removing it and using a small puller to force the ballstud out. For models from 1994 and earlier, loosen the clamp bolts on the tie-rod adjusting sleeve; for 1995 and later models, loosen the tie-rod end jam nut and back it off several turns. Mark the threads adjacent to the adjusting sleeve or tie-rod end, then unscrew the tie-rod end from the adjusting sleeve or connecting rod. For installation, insert the tie-rod end into the adjusting sleeve or connecting rod, threading it in until the marks align. Attach the tie-rod onto the steering spindle, ensuring the front wheels and steering wheel are straight and the tie-rod stud is seated properly to prevent rotation while tightening the nut. Install a new nut on the stud and tighten it to the specified torque, then add a new cotter pin and bend the ends over completely. Tighten the tie-rod adjusting sleeve clamp bolts or jam nut to the specified torque, ensuring the tie-rod is positioned as it was originally. Finally, install the wheel and lug nuts, lower the vehicle, and tighten the lug nuts to the specified torque, followed by having the front-end alignment checked by a dealer service department or an alignment shop.