Ford 5L5Z-16005-A Fender Assembly - Front

You can Select Your Vehicle to check if 5L5Z-16005-A fits your vehicle.

It will be relevant to observe that before beginning with fender fasteners it is better to wipe with high pressure hose especially in the wheel well to clear the dirt; There can be situations where one has to take of the front bumper. Starting with the removal front side marker lamp. After that, lose the lower rear corner of the fender to the rocker panel, then open its door to get rid of the single cowl-to-fender bolt. The panel on which the radiator grille is located has to be unbolted; then the headlamps have to be dismantled to get at this panel. Following that, undo the screws and take out the inner fender panel that is present at the rear of the 4WD. Pop the hood and take out the bolts that run along the top of the fender, as well as the bolts of the fender brace from the radiator support; gently pull the fender off the car. For installation, therefore, several well-lit steps must be taken in reverse of the above extraction procedure, while it is important to tighten every bolt in existence without the tightening of others before that.

Installation is the reverse of the removal procedure. Don't tighten any of the bolts until they are all installed.