Ford FA1Z-16612-A Hood Assembly

You can Select Your Vehicle to check if FA1Z-16612-A fits your vehicle.

The hood is awkward to remove and install, so at least two people should perform this procedure. Begin by opening the hood and placing blankets or pads over the fenders and cowl area to protect the body and paint. Make marks around the hood hinge for proper alignment during reinstallation. If equipped, disconnect the windshield wiper hose connection and hose retaining clip from the hood. Use a small screwdriver to detach the retaining clips at both ends of the support strut, then pry or pull sharply to detach it from the vehicle. Have an assistant support one side of the hood while you grasp the lower corner and brace it with your shoulder, taking turns to remove the hinge-to-hood bolts and lift off the hood. For installation, align the hinge bolts with the marks made earlier. Fore-and-aft and side-to-side adjustments can be made by moving the hinges after loosening the hinge-to-body bolts; adjust the hood gradually and tighten the bolts before checking the position. The hood can also be adjusted vertically using the two height adjustment cushions on the underside, turning them clockwise to lower or counterclockwise to raise the hood. Periodically lubricate the hood latch assembly and hinges with white lithium-base grease to prevent binding and wear. To remove and install the hood support struts, open the hood and support it securely, then detach the retaining clips at both ends of the support strut and pry or pull sharply to detach it from the ballstuds, with installation being the reverse of removal.