Ford K2GZ-1104-A Wheel Hub Assembly

You can Select Your Vehicle to check if K2GZ-1104-A fits your vehicle.

2014 and earlier models require special tools and expertise to press the hub and bearing from the steering knuckle, this job should be left to a professional mechanic. However, the steering knuckle and hub may be removed and the assembly taken to an automotive machine shop or other qualified repair facility equipped with the necessary tools. For 2015 and later models, caution is advised as the manufacturer recommends to replace all removed suspension component fasteners (nuts and bolts) with new ones. Apply the parking brake, loosen the wheel lug nuts and raise the front of the vehicle. Support it securely on jack stands and remove the wheel. Remove the brake disc. Remove the hub dust cap and nut, then push the drive axle through the hub splines as the hub and bearing assembly is removed. Be careful not to over extend the inner CV joint. Once the hub has been removed, support the outer end of the drive axle with a length of wire or rope. Remove the four bolts securing the hub assembly to the steering knuckle, then remove the hub and bearing assembly. Installation is the reverse of removal. Replace all suspension fasteners that were removed with new fasteners and tighten them to the values listed in the Specifications. Install the wheels, lower the vehicle and tighten the wheel lug nuts to the torque listed in the Specifications.

For 2011 and later models, install the wheel hub/bearing assembly onto the rear knuckle, guiding the drive axle into the splines for all-wheel drive models. Tighten the hub assembly-to-rear knuckle bolts to the specified torque. The remainder of the installation is the reverse of the removal process. Tighten brake fasteners, and for all-wheel-drive models, tighten the drive axle/hub nut(s). Install the wheel and lug nuts, lower the vehicle, and torque the lug nuts.