Ford 6L8Z-10849-SB Instrument Cluster

You can Select Your Vehicle to check if 6L8Z-10849-SB fits your vehicle.

This procedure is intended for removing the instrument cluster for access to other components only. If the instrument cluster requires replacement, the job will have to be performed at a dealer service department or other qualified repair shop equipped with the special scan tool that is required to upload the module configuration data and download this data into the new cluster. Disconnect the cable from the negative battery terminal. Tilt the steering wheel to its lowest position and move the transaxle shift lever out of the way. On 2007 and earlier models, remove the cluster bezel screws and remove the cluster bezel. On 2008 and later models, use a plastic trim tool or a screwdriver wrapped with tape to carefully pry off the bezel. Remove the instrument cluster retaining screws, then pull out the cluster and disconnect the electrical connectors from the back side. Installation is the reverse of removal. After you've reconnected the battery, the Powertrain Control Module (PCM) must relearn its idle and fuel trim strategy for optimum driveability and performance.

Once you've disconnected the harness connectors, proceed by removing the hood latch bolts and positioning the assembly aside without disconnecting the cable. You should also remove the utility compartment and take off the steering column covers.

After disconnecting the battery and removing the steering wheel, you should proceed to remove the passenger's side airbag, the audio unit from the center of the dashboard, and the heater/air conditioner control assembly.

On 2008 and later models, a plastic trim tool or a screwdriver wrapped with tape should be used to carefully pry off the bezel.