Ford F3TZ-7000-DRM Reman Automatic Transmission Kit

You can Select Your Vehicle to check if F3TZ-7000-DRM fits your vehicle.

Transmission gear selection and converter clutch operation in the Overdrive range is controlled by the Electronic Engine Control system.

The initial steps for removing the transmission are as follows:1. Disconnect the battery negative cable.2. Drain the transmission lubricant into a suitable container.

Some suggestions for a successful transmission overhaul include obtaining exploded-view drawings of the particular transmission, creating diagrams or taking photos during disassembly, laying out each part in order, checking for missed bolts or snap rings before applying force, and anticipating which parts may need replacement and having them available beforehand.

Yes, regardless of year, all transmissions are fully synchronized with all gears, except the reverse sliding gear, which is in constant mesh.

The AOD transmission uses a governor and throttle valve rod or cable for speed and load sensing.

To install the transmission, follow these steps:1. Push in and turn the converter to engage it with the front pump.2. Rotate the converter to align the bolt drive lugs and drain plug with the driveplate holes. Avoid a "nose-down" attitude to prevent disengagement of the converter from the pump gear.3. If the torque converter is bolted to the driveplate, position it with one bolt hole at the six o'clock position and install all bolts before tightening.4. Adjust the kickdown rod/cable, TV rod/cable, and manual selector linkage as needed.5. Lower the vehicle and add fluid to the Max mark on the dipstick with the engine off.6. Start the engine, check the fluid level, and top up if necessary.