Ford 8S4Z-9424-G Manifold Assembly - Inlet

You can Select Your Vehicle to check if 8S4Z-9424-G fits your vehicle.

Remove the intake manifold brace, unbolt the intake manifold brace, and the bolts/nuts that secure the manifold. Slide the manifold off the studs and remove the gasket. The IMRC can remain in place on the intake studs.

To remove the intake manifold on models through 2004, follow these steps:1. Depressurize the fuel system and disconnect the negative battery cable.2. Remove the air cleaner and inlet duct, and disconnect the accelerator cable.3. For 2.3L and 2005 and later 2.0L models, remove the engine cooling fan and shroud.4. Disconnect the brake booster vacuum hose from the base of the manifold and remove the engine oil dipstick and its tube.5. Disconnect the injection harness wiring plug and camshaft position sensor at the rear of the cylinder head.6. Disconnect all electrical connectors from the throttle body.7. For models through 2004, disconnect the fuel supply and return lines from the fuel rail, protecting the alternator from fuel spillage.8. If equipped, disconnect the intake manifold runner control (IMRC) cable.9. Remove the manifold support bracket (SPI engines) and manifold retaining bolts.10. Withdraw the manifold from the engine, keeping it as level as possible, and recover the four gaskets (new ones must be used on installation).

There are three sizes of bolts, so make note of their locations on disassembly.