Ford BT4Z-17508-A Motor Assembly - Wiper

You can Select Your Vehicle to check if BT4Z-17508-A fits your vehicle.

To replace the front wiper motor, unbolt the wiper arm nuts and place the wiper arms in the same position that there are on their shafts before both are removed. Then remove a plastic cowl cover, pull out the electrical connector from the wiper motor, and then unscrew two screws in order to get the wiper motor and link assembly. Take out the linkage from the motor's crank arm gently with a trim removal tool or screwdriver and undo the nut of the crank arm with the motor shaft. Locate the crank arm against the motor shaft and unfasten it; likewise the two bolts which secures the motor in position must also be removed to unbolt the motor. For The rear wiper motor, unbolt the wiper arm nut and state the position of the wiper arm on the shaft before the wiper arms are then unscrewed. Next, you need to pull off the liftgate trim panel, then, disconnect the electrical connector from the wiper motor, then, remove mounting bolts to have the wiper motor out. The installation for both motors is as follows: The removal process When installing both motors remember to reverse the following steps.

How to fix the front wiper motor. First of all, put off the wiper arm nuts and note their position on the wiper shafts before, both arms to be removed. After that, remove the plastic cowl cover, pull the electrical connector of the wiper motor, and then remove two screws to extract wiper motor and link assembly. Remove the linkage by slowly prying it from the motor's crank arm with a trim removal tool or a screwdriver, and unbolt the nut holding the crank arm to the motor shaft. Locate the crank arm position to the motor shaft, where you have to remove the crank arm to use it as a template after loosening the two motor mounting bolts to pull out the motor from this bracket. For the rear wiper motor, start like this, you have to drop the wiper arm nut and note the position of the arm on the shaft before you take off the wiper arms. Then, to gain access, pop out the lift gate trim panel, unplug the electrical connection of the wiper motor and then pull out the mounting bolts to pull out the wiper motor. Disassembly and installation processes of both motors are contrary to the steps discussed above.