Ford E8TZ-7B215-A Seal

You can Select Your Vehicle to check if E8TZ-7B215-A fits your vehicle.

Raise the vehicle and support it securely on jackstands.

To replace the fuel pump, follow these steps:1. Remove the fuel pump/sending unit assembly from the vehicle carefully.2. Install a new rubber gasket during reassembly.3. Adjust the angle and travel distance if the float arm and float wire loop were damaged during removal and installation.

To replace the oil seal, apply multi-purpose grease and position it squarely into the case bore with the markings facing outwards. Drive the seal into the bore using an appropriately sized seal driver or equivalent tool.

A 30mm (1.18 in.) thin-wall socket.

To replace the fuel pump, follow these steps: 1. Remove the fuel pump/sending unit assembly from the vehicle carefully. 2. Install a new rubber gasket during reassembly. 3. Adjust the angle and travel distance if the float arm and float wire loop were damaged during removal and installation.

If the filler plug is higher than the lowest part of the seal, to prevent fluid loss during seal removal.

Lower the vehicle and reconnect the negative battery cable.

Using Impact Slide Hammer Tool TSOT-100:-A or equivalent.

Seal installer T74P-77052-A or equivalent.

After replacing the oil seal, clean and lightly lubricate the yoke splines, then slip the slinger and yoke over the output shaft and past the new seal until it bottoms. Coat the face of the yoke retaining nut with RTV sealant and apply thread locking compound to the threads. Install the rubber seal, washer, and yoke retaining nut onto the output shaft, tightening it to the specified torque.