Ford F87Z-4602-CA Drive Shaft Assembly

You can Select Your Vehicle to check if F87Z-4602-CA fits your vehicle.

Since the driveshaft is a balanced unit, it's important that no undercoating, mud, etc., be allowed to stay on it. When the vehicle is raised for service, it's a good idea to clean the driveshaft(s) and inspect it for any obvious damage. Also, check that the small weights used to originally balance the driveshaft(s) are in place and securely attached. Whenever a driveshaft is removed, it should be reinstalled in the same relative position to preserve the balance.

Wrap tape around the universal joint bearings at the axle end of the driveshaft so they won't fall out.

Installation is the reverse of the removal steps with the following additions: Raise the front of the driveshaft into position, ensuring the marks are in alignment. If not, make sure the transmission is still in Neutral, then turn the front wheels to line up the marks. Remove the tape securing the bearing cups and install the straps and bolts. Tighten the bolts to the torque specifications. On 2011 models, tighten the driveshaft-to-transfer case bolts in a crisscross pattern, to the torque specifications.

Removal of the drive shafts and drive axle.

The universal joints must be replaced if problems develop, and the driveshaft(s) must be removed from the vehicle for this procedure.