Ford 4L5Z-4602-AA Drive Shaft Assembly

You can Select Your Vehicle to check if 4L5Z-4602-AA fits your vehicle.

The slip yokes on the driveshafts and the right front drive axle.

Whenever a driveshaft is removed, it's important that it be reinstalled in the same relative position to preserve the balance.

Problems with the driveshaft(s) are usually indicated by a noise or vibration while driving the vehicle. A road test should verify if the problem is the driveshaft(s) or another vehicle component. Steps include noting the engine speed at which the problem is most evident, testing the vehicle in different gear ranges, and visually inspecting the driveshaft(s) for damage or imbalance.

Installation is the reverse of the removal steps with the following additions: a) On 2WD models, slide the front of the driveshaft into the transmission. b) On 4WD models, position the front end of the driveshaft on the transfer case with the alignment marks lined up. c) Raise the rear of the driveshaft into position, checking to ensure the marks are in alignment. If not, make sure the transmission is still in Neutral, then turn the rear wheels to match the pinion flange and the driveshaft. d) On 2011 models, tighten the driveshaft-to-axle bolts in a crisscross pattern, to the torque.

Disconnect the negative cable from the battery.