Ford 9L3Z-4R602-SE Drive Shaft Assembly

You can Select Your Vehicle to check if 9L3Z-4R602-SE fits your vehicle.

Two-piece driveshafts consist of two separate sections connected by a center support bearing, while one-piece driveshafts are a single unit. The slip yoke in the driveshaft assembly allows the driveshaft to alter its length during vehicle operation. In two-piece driveshafts, the slip yoke is part of the shaft and is typically found at the front or rear section of the driveshaft.

To remove the front driveshaft on models with CV joints, you should remove the driveshaft shield, mark the relationship of the driveshaft to the differential mating flange, and then proceed to remove the bolts securing the front end of the driveshaft to the differential mating flange and the driveshaft universal joint to the transfer case.