Ford F2GZ-5310-C Spring - Front

You can Select Your Vehicle to check if F2GZ-5310-C fits your vehicle.

On all-wheel drive models, after removing the necessary components, the drive axle needs to be pulled out, the jack needs to be lowered while pulling out on the knuckle, and then the coil spring can be removed.

1. Guide the assembly up into the fenderwell. 2. Align the previously made match marks. 3. Insert the upper mounting studs through the holes in the body. 4. Once the studs protrude, install the new nuts to prevent the shock from falling back through, but don't tighten them yet. 5. Use the jack to position the steering knuckle. 6. Install the two lower mounting bolts and nuts. 7. Tighten the nuts to the specified torque. 8. Install the wheel and lug nuts. 9. Lower the vehicle and tighten the lug nuts to the specified torque. 10. Finally, tighten the upper mounting nuts to the specified torque.

To reassemble, install the lower spring seat, bump stop, and dust boot onto the shock absorber, followed by the spring and upper mount/upper seat, aligning the arrow or notch appropriately.