Ford BT4Z-5560-A Spring - Rear

You can Select Your Vehicle to check if BT4Z-5560-A fits your vehicle.

For 2010 and earlier models, the removal steps include removing the brake caliper, brake disc, brake cable bracket, stabilizer bar link, and wheel speed sensor. On all-wheel drive models, the inner and outer drive axle/hub nuts need to be removed and the drive axle needs to be separated from the hub and bearing using a drive hub remover.

If a new spring is to be installed, release the original spring from the compressor; otherwise, it can remain in compression.

1. Guide the assembly up into the fenderwell. 2. Align the previously made match marks. 3. Insert the upper mounting studs through the holes in the body. 4. Once the studs protrude, install the new nuts to prevent the shock from falling back through, but don't tighten them yet. 5. Use the jack to position the steering knuckle. 6. Install the two lower mounting bolts and nuts. 7. Tighten the nuts to the specified torque. 8. Install the wheel and lug nuts. 9. Lower the vehicle and tighten the lug nuts to the specified torque. 10. Finally, tighten the upper mounting nuts to the specified torque.