Ford BT4Z-5560-J Spring - Rear

You can Select Your Vehicle to check if BT4Z-5560-J fits your vehicle.

1. Guide the assembly up into the fenderwell. 2. Align the previously made match marks. 3. Insert the upper mounting studs through the holes in the body. 4. Once the studs protrude, install the new nuts to prevent the shock from falling back through, but don't tighten them yet. 5. Use the jack to position the steering knuckle. 6. Install the two lower mounting bolts and nuts. 7. Tighten the nuts to the specified torque. 8. Install the wheel and lug nuts. 9. Lower the vehicle and tighten the lug nuts to the specified torque. 10. Finally, tighten the upper mounting nuts to the specified torque.

After the installation process, the rear wheel alignment should be checked and adjusted as needed.

With the spring compressed, install the rod nut, ensuring the ends of the spring fit into the recessed portion of the seats and maintaining the specified gap. Tighten the nut to the prescribed torque while keeping the position at both ends consistent.

After the installation process, the rear wheel alignment should be checked and adjusted as needed.

Finally, release the spring tension and reinstall the spring assembly in the vehicle.

Have the front end alignment checked, and if necessary, adjusted.