Ford G2GZ-5560-A Spring - Rear

You can Select Your Vehicle to check if G2GZ-5560-A fits your vehicle.

On all-wheel drive models, after removing the necessary components, the drive axle needs to be pulled out, the jack needs to be lowered while pulling out on the knuckle, and then the coil spring can be removed.

Subsequently, remove the upper mount, spring, boot, bump stop, and lower spring seat.

1. Loosen the wheel lug nuts. 2. Raise the vehicle and support it securely on jack stands. 3. Remove the wheel. 4. Unbolt the brake hose bracket from the shock absorber. 5. Remove the wheel speed sensor and detach the wiring harness by removing the clamp bracket bolt. 6. On 2015 and later models, remove the stabilizer bar link nut and disconnect the link from the strut. 7. Support the control arm with a floor jack. 8. Unscrew the nuts securing the strut to the steering knuckle. 9. Tap the bolts out with a hammer. 10. Use the floor jack to lower the knuckle to allow room to remove the shock absorber/coil spring assembly, being careful not to overextend the inner CV joint.