Ford F2TZ-11572-B Switch Assembly - Ignition

You can Select Your Vehicle to check if F2TZ-11572-B fits your vehicle.

To replace the ignition switch, another matter is to remove the negative battery cable and the positive battery cable if the car is fitted with airbags. Rotate the ignition key lock cylinder as far as possible to the right, by turning it anti-clockwise. There are two panels known as driver side lower instrument panel cover and the reinforcement panel which must be unbolted. The ignition switch electrical connector and, in turn, the switch retaining screws has to be disconnected. Release the ignition switch from the actuator rod and remove the switch out of the car. Make sure the new ignition switch is in the OFF state and then position it on the required position and hook the actuator rod. This part has to be fitted and fixed in place using the tightening of the retaining screws. Last, the other remaining steps are what remains of the installation and as always be sure to check the switch going to lock, start, accessory and make sure it is working properly.

Remove the steering wheel, steering column lower cover, and steering column shrouds.