Ford 7T4Z-8620-C V-Belt

You can Select Your Vehicle to check if 7T4Z-8620-C fits your vehicle.

Yes, there are specific procedures for "stretchy belts" and tensioners for 1.5L and 1.6L engines.

To replace the accessory drivebelt on four-cylinder models up to 2014, follow these steps: Disconnect the battery cable. Loosen the right front wheel lug nuts. Raise the vehicle and remove the wheel and splash shield. Release belt tension and replace the belt, ensuring proper routing.

To replace the belt, disconnect the cable from the negative terminal of the battery, loosen the right front wheel lug nuts, raise the front of the vehicle, and remove the right front wheel and splash shield. Note the routing of the drivebelt, then remove it from the pulleys. Install the new drivebelt onto the pulleys, making sure it is correctly seated, then release the tensioner. Install the splash shield and wheel, then lower the vehicle and tighten the lug nuts.

The accessory drivebelt is a vital component at the front of the engine, responsible for driving various components like the alternator, power steering pump, and water pump. It's susceptible to wear and should undergo periodic inspection to ensure it's in good condition. Inspecting the belt is essential to catch signs of wear, damage, or potential issues early.