Lincoln YW7Z-5A772-AA Bar - Stabilizer

You can Select Your Vehicle to check if YW7Z-5A772-AA fits your vehicle.

Raise and secure the vehicle on jackstands. Disconnect the sway bar kit from the links by removing the nut at each end. Use pliers to hold the link if attached to lower control arms. For 1992 and later models, remove the nut from each end if links are attached to steering knuckles. Remove the bracket nuts and brackets to detach the bar from the frame. Remove the sway bar kit and reverse steps for installation, ensuring all fasteners are correctly tightened.

Remove the four stabilizer bar-to-lower suspension arm bolts on pre-1992 models.

Remove the nut from each end of the stabilizer bar.

Before driving a vehicle equipped with air suspension, the air suspension switch should be turned to On, the engine should be started, and the compressor should be allowed to inflate the air suspension springs, which deflate automatically when the rear of the vehicle is raised.

Remove the stabilizer bar clamp nuts and remove the clamps.

The axle housing must be free to hang down so that the shock absorbers are fully extended.