Lincoln DA8Z-8620-B Belt

You can Select Your Vehicle to check if DA8Z-8620-B fits your vehicle.

The accessory drive-belt is very important for the engine and its various components. It drives the alternator, power steering pump, water pump, and air conditioner compressor. To check for belt wear and damage, lift up the front of the vehicle, wheel removal, right side, and splash shield and look for any cracks, separation, fraying, or glazed appearance. To replace it, disconnect the battery cable, lift up the vehicle by using a wheel remover or jack stand, and remove the wheel/splash guard to get to the Belt on 3.6L VVT V6 engine-equipped vehicles only. Disconnect the battery cable, lift the vehicle while removing the wheel/splash guard. Also, flexible material makes it possible to remove the old belt and install a new one instead of replacing this belt.

The steps to replace the serpentine drivebelt are as follows: 1. Disconnect the battery cable. 2. Loosen wheel lug nuts. 3. Raise the vehicle. 4. Remove the wheel and splash shield. 5. Support the engine if necessary. 6. Follow specific steps based on the engine model to release tension and remove the old belt. 7. Install the new belt, ensuring proper routing and seating in pulley grooves. 8. Reassemble and lower the vehicle.

Some models have unique stretchy belt designs, such as the air conditioning compressor drivebelt for 2015 and later four-cylinder engines and the power steering pump drivebelt for 2014 and earlier V6 engines. Careful removal and installation are crucial for these belts.

The accessory drivebelt is a vital component at the front of the engine, responsible for driving various components like the alternator, power steering pump, and water pump. It's susceptible to wear and should undergo periodic inspection to ensure it's in good condition. Inspecting the belt is essential to catch signs of wear, damage, or potential issues early.