Lincoln 6L1Z-2V120-ERM Brake Caliper Assembly-Less Pads

You can Select Your Vehicle to check if 6L1Z-2V120-ERM fits your vehicle.

Proceed to remove the caliper mounting bolts and the caliper itself. Clean the caliper using brake system cleaner (avoid kerosene or petroleum-based solvents). Carefully remove the dust boot(s) from the caliper and use compressed air applied through the hydraulic fluid inlet to force the piston(s) out of the bore(s), placing a wooden block between the caliper bridge and piston(s). Remove the piston seal(s) using a plastic or wooden tool and clean the piston(s) and cylinder bore(s) with brake system cleaner or clean brake fluid.

Lubricate the caliper bore(s) and piston(s) with clean brake fluid, then insert the piston(s) into the bore(s). Ensure the piston(s) are aligned correctly, depress them partially into the bore with a C-clamp and a wooden block. Seat the boot properly and push the piston(s) fully into the bore. Install the large anti-rattle clip if it was removed and ensure it's properly seated.