Lincoln F75Z-9943170-AA Control

You can Select Your Vehicle to check if F75Z-9943170-AA fits your vehicle.

To begin the process of treating with the door trim panel and water shield, use the screws to unlatch the inner door handle assembly from the door. Subsequently, remove the handle link from the handle and the lock cylinder. For models from year 2001 onwards, the front door glass run channel bolt near the lower rear of the door has to be dozed and the glass guide fastener has to be loosened for the adjustment of the door glass. Get rid of the rods in the latch, then take out the latch screws and sliding away the latch assembly through the use of the Torx screws which holds it firmly to the door. For installation, it is done in the reversal of the process of removal and in the process, make sure that the rod retaining clips will be installed if a new latch is being put. Well push the control rod and place the lock cylinder rod on the latch then screwed to fasten it, examine the handle and lock before fixing the water shield and door panel back.

The door latch strikers should be lubricated with a thin coat of grease to reduce wear and ensure free movement.

Remove the screws securing the latch to the door (Remove the latch retaining screws from the end of the door).

They should be lubricated with a thin coat of grease to reduce wear and ensure free movement.

Remove the latch mounting fasteners by taking out the tailgate latch retaining screws. It may be necessary to use an impact-driver to loosen them.

Once every 3,000 miles, or every three months.