Lincoln 8E5Z-5G232-C Exhaust Manifold And Catalyst Assembly

You can Select Your Vehicle to check if 8E5Z-5G232-C fits your vehicle.

To remove the catalytic converter on 2010 and later models with a 2SL four-cylinder engine and Non-Partial Zero Emissions (PZEV) vehicles, raise the vehicle and place it securely on jackstands. Disconnect the downstream oxygen sensor's electrical connector, unscrew and remove the downstream oxygen sensor from the catalyst. Remove the nuts and bolts securing the flange at the front end of the catalyst to the exhaust down pipe. Loosen the fasteners on the clamp securing the rear end of the catalyst to the exhaust system. Remove the catalytic converter and old gasket between the exhaust down pipe and the catalyst mounting flange. Installation is the reverse of removal, using a new gasket and, if necessary, new fasteners.

The remainder of the installation is the reverse of the removal procedure.

1.5L and 2.0L models do not use an exhaust manifold; the exhaust manifold has been partially cast into the cylinder head, and the turbocharger mounts directly to the cylinder head.