Lincoln 8A1Z-18125-D Kit - Shock Absorber

You can Select Your Vehicle to check if 8A1Z-18125-D fits your vehicle.

1. Loosen the wheel lug nuts. 2. Raise the vehicle and support it securely on jack stands. 3. Remove the wheel. 4. Unbolt the brake hose bracket from the shock absorber. 5. Remove the wheel speed sensor and detach the wiring harness by removing the clamp bracket bolt. 6. On 2015 and later models, remove the stabilizer bar link nut and disconnect the link from the strut. 7. Support the control arm with a floor jack. 8. Unscrew the nuts securing the strut to the steering knuckle. 9. Tap the bolts out with a hammer. 10. Use the floor jack to lower the knuckle to allow room to remove the shock absorber/coil spring assembly, being careful not to overextend the inner CV joint.

Ensure the vehicle is parked on level ground with the engine off and the parking brake engaged while verifying tire pressures.

If a new spring is to be installed, release the original spring from the compressor; otherwise, it can remain in compression.

If the shock absorber is going to be replaced on 2015 and later models, remove the piston rod nut and separate the upper mounting bracket.