Lincoln 5F9Z-9G444-AB Sensor - Exhaust Gas - Oxygen

You can Select Your Vehicle to check if 5F9Z-9G444-AB fits your vehicle.

When servicing an oxygen sensor, it is fixed on the exhaust manifold or pipe and becomes very tight to undo; to avoid damaging the sensor or the threads on which it is fixed or screwed, it is advisable to start the engine for sometime, especially for a minute or two. An oxygen sensor comes with a pigtail and an electrical connector that is not supposed to be tampered with and or detached and should not come into contact with grease, dirt among other dirt causing substances on the electrical connector and on the louvered end of the sensor. Cleaning solvents can be used but must not be used on the oxygen sensor because this is one of the delicate parts which must not be dropped or bumped. Check on the placement of the silicone boot on the sensor to avoid cases of melting and other problems in the operations. To replace the sensor remove the cable from the negative terminal of the battery, lift the front of the car ensuring it is on jack stands and then remove the engine under cover. Find the upstream oxygen sensor and remove its electrical connection, and release the clips before using a wrench or an oxygen sensor socket to remove it. If it is the old sensor to be reinstalled, one needs to coat anti-seize compound on the threads but in a new one, there is a protection of anti-seize compound. Installation is done in a sequence and the torque on the sensor must be tightened to the prescribed standard. The same applies for the downstream oxygen sensor insofar as again you have located and disconnected it and finally unscrewed it, if it is the original sensor then apply the anti-seize compound and tighten the sensor to the required torque specification when next fixing it.

It is difficult to loosen an oxygen sensor when the engine is cold because it is installed in the exhaust manifold or pipe.

When replacing the upstream oxygen sensor, you should ensure that the silicone boot on the sensor is installed correctly to prevent melting and ensure proper operation.

To replace the upstream oxygen sensor, you need to locate it, disconnect the electrical connector, and then unscrew the sensor using a wrench or oxygen sensor socket. Apply anti-seize compound to the threads if reusing the old sensor.