Lincoln 5L8Z-9F472-BA Sensor - Hego

You can Select Your Vehicle to check if 5L8Z-9F472-BA fits your vehicle.

An oxygen sensor functions as a galvanic battery that generates a small voltage output based on the oxygen levels in exhaust gases, providing essential input for the feedback loop with the Powertrain Control Module (PCM) to maintain the ideal air/fuel ratio of 14.7:1 for optimal catalyst performance. Vehicles equipped with On-Board Diagnostics II (OBD-II) utilize two oxygen sensors-one before and one after the catalytic converter-to assess converter efficiency by comparing oxygen levels in the exhaust gases. Four-cylinder models feature one upstream and one downstream heated oxygen sensor, while V6 models have four heated sensors, with two for each cylinder head and multiple catalysts. All sensors are heated to reduce warm-up time, and care must be taken during servicing to avoid damaging the permanently attached pigtail and electrical connector, as well as to keep contaminants away from the sensor. When replacing an oxygen sensor, it is advisable to warm the engine to ease removal, apply anti-seize compound to the threads if reusing an old sensor, and ensure proper torque during installation. After reconnecting the battery, the PCM must relearn its idle and fuel trim strategy for optimal performance.

You should keep grease, dirt, and other contaminants away from the electrical connector and the louvered end of the sensor.

1. Disconnect the negative battery terminal. 2. Disconnect the upstream oxygen sensor electrical connector. 3. Raise the front of the vehicle and secure it on jackstands. 4. Locate and unscrew the upstream oxygen sensor. 5. Apply anti-seize compound if reinstalling the old sensor. 6. Install the sensor and tighten it to the specified torque. 7. Reconnect the battery and allow the PCM to relearn its idle and fuel trim strategy.