Lincoln 5L7Z-4R602-AA Drive Shaft Assembly

You can Select Your Vehicle to check if 5L7Z-4R602-AA fits your vehicle.

The driveshaft sends engine power to the rear axle through the transmission. At either end of a driveshaft universal joints are used. Although many U-joints are single-cardan type, some 4WD models have double-cardan U-joints. A slip yoke is located at the front of a rear driveshaft, and it connects to a differential by means of a flange yoke. Front driveshafts on 4WD have a slip yoke on each end. The only time a driveshaft may need attention is when the universal joints wear out and need replacing as they are serviceable items which require little maintenance otherwise. Additionally, the driveshaft should be inspected for damage during service procedure and cleaned of any debris that might be present in order for it to function properly again as well.

To install, bolt the front end to the front axle differential pinion flange. Attach the rear end to the transfer case output shaft companion flange. Secure the front driveshaft shield.