Lincoln BL3Z-4602-C Drive Shaft Assembly

You can Select Your Vehicle to check if BL3Z-4602-C fits your vehicle.

U-joints are responsible for transferring the torque from the transmission to the rear differential on a driveshaft. Single-cardan, double-cardan, and constant velocity are the three kinds of U-joints. In some car models, two halves comprise the drive shaft, with a support bearing in between them. At the back part, there is a splined yoke joining the rear driveshaft to the transmission while at the front end, there is a slip yoke on both the front driveshaft and rear half of a two-piece driveshaft. To prevent leakage and dirt entry, an oil seal is used. The driveshaft requires little service although factory U-joints should be replaced if any problems arise with them. It is important to keep clean and balance your driveshaft.

If the shaft cannot be lined up due to rotated components, you should put the vehicle in Neutral or rotate one wheel to allow the original alignment to be achieved.