Lincoln F8VZ-18125-AA Shock Absorber Assembly

You can Select Your Vehicle to check if F8VZ-18125-AA fits your vehicle.

Before installing a new hydraulic shock absorber, expel all air by extending and compressing it multiple times. Place the inner washer and rubber insulator on the shock piston rod and insert the rod through the upper mounting hole in the frame. Install the outer insulator, washer, and a new stud retaining nut on the upper side of the frame. On specific models, install the inner washer and rubber insulator on the shock rod and insert the rod through the upper mounting hole. Push up on the shock absorber to align the lower shock eye in the mounting bracket and install the bolt and nut. Then install the upper mounting rubber insulator and the dished washer on the shock rod and tighten the nut. Extend the shock absorber, insert the lower shock stud through the hole in the bracket on the axle tube, and install a new self-locking retaining nut. Attach the air line(s), if equipped.

The floor jack can be removed from under the control arm.

A floor jack can be used to raise the lower control arm if necessary.

Replace the shocks as a set if leakage is present.