Lincoln 8E5Z-18125-A Shock Absorber Assembly

You can Select Your Vehicle to check if 8E5Z-18125-A fits your vehicle.

Tighten the mounting fasteners to the torque. Note: Any rear suspension fasteners should be replaced with new fasteners on assembly and should only be tightened with the hub raised to a height of 15.5 inches from the hub center to the center of the fenderwell.

Connect the stabilizer bar link to the damper fork or strut. Tighten the nut to the torque. The remainder of installation is the reverse of removal.

Examine the shock for signs of fluid leakage. Check the piston rod for signs of pitting along its entire length, and check the shock body for signs of damage. Test the operation of the shock, while holding it in an upright position, by moving the piston through a full stroke, then through short strokes of 2 to 4 inches. In both cases, the resistance felt should be smooth and continuous. If the resistance is jerky or uneven, or if there is any visible sign of wear or damage, replacement is necessary.

Raise and securely support the vehicle on jackstands for a closer inspection.