Lincoln F2GZ-18124-R Shock Absorber Assembly

You can Select Your Vehicle to check if F2GZ-18124-R fits your vehicle.

Attempt to move each control arm up and down to check for play in the ball joints. If there is play, replace the worn ball joint.

With the spring compressed, install the rod nut, ensuring the ends of the spring fit into the recessed portion of the seats and maintaining the specified gap. Tighten the nut to the prescribed torque while keeping the position at both ends consistent.

Support the rear lower control arm with a floor jack, then remove the lower shock absorber nut and bolt.

1. Loosen the wheel lug nuts. 2. Raise the vehicle and support it securely on jack stands. 3. Remove the wheel. 4. Unbolt the brake hose bracket from the shock absorber. 5. Remove the wheel speed sensor and detach the wiring harness by removing the clamp bracket bolt. 6. On 2015 and later models, remove the stabilizer bar link nut and disconnect the link from the strut. 7. Support the control arm with a floor jack. 8. Unscrew the nuts securing the strut to the steering knuckle. 9. Tap the bolts out with a hammer. 10. Use the floor jack to lower the knuckle to allow room to remove the shock absorber/coil spring assembly, being careful not to overextend the inner CV joint.