Mercury 8G1Z-5A772-B Bar - Stabilizer

You can Select Your Vehicle to check if 8G1Z-5A772-B fits your vehicle.

Place the shifter in the Neutral position. Detach the oxygen sensor harness from the rear of the subframe, then disconnect the electrical connector. If you're working on an all-wheel drive model, remove the exhaust Y pipe and the front catalytic converter. If you're working on a 2007 or earlier model, remove the rear catalytic converter.

Start by loosening the rear wheel lug nuts, raising the rear of the vehicle, and supporting it securely on jackstands, then remove the wheels. Lower the exhaust system from the rear of the flex pipe and remove the stabilizer bar link to stabilizer bar nuts on both sides. Proceed to remove the bolts holding the stabilizer bar bushing brackets and the stabilizer bar itself. While the stabilizer bar is off the vehicle, inspect the bushings, and if they are cracked, worn, or deteriorated, the stabilizer bar must be replaced. Installation is the reverse of removal, tightening the fasteners to the specified torque values. Install the wheel and lug nuts, then lower the vehicle and tighten the lug nuts to the torque.