Mercury 3L8Z-4207-EA Differential And Carrier Assembly

You can Select Your Vehicle to check if 3L8Z-4207-EA fits your vehicle.

To remove the differential on 2004 and earlier models, raise the vehicle and support it on jackstands. Remove the driveshaft, driveaxles, and differential bracket bolt. Disconnect the electrical connector and support the differential with a floor jack. Remove the four bolts securing it and carefully remove the differential. For installation, reverse the steps. On 2005 and later models, raise the vehicle and remove the spare tire, driveaxles, and driveshaft. Support the differential with a floor jack, disconnect the wiring and remove the front mounting brackets. With help, remove the three rear bolts, lower and remove the differential. Reverse steps for installation.

For installation, follow the reverse steps. Make sure to install all the mass damper bolts finger tight first and then tighten them in the proper sequence.