Mercury 5F9Z-1104-AB Hub Assembly - Wheel

You can Select Your Vehicle to check if 5F9Z-1104-AB fits your vehicle.

Loosen the wheel lug nuts and raise the vehicle, supporting it securely on jackstands. Remove the wheel. With an assistant applying the brake, remove the driveaxle/hub nut, but keep the old nut for now. Remove the brake caliper, caliper mounting bracket, and brake disc from the hub. Suspend the caliper to the strut coil spring with wire. Push the driveaxle into the hub using a drive hub remover or equivalent puller. Remove the hub and bearing-to-steering knuckle bolts, separating the assembly from the knuckle. Ensure the mounting surface inside the knuckle and driveaxle splines are smooth. Install the hub/bearing assembly to the knuckle using new mounting bolts. Install the brake disc, caliper mounting bracket, and caliper. Seat the driveaxle by using the old driveaxle/hub nut and washer, tightening it to the specified torque. Replace the old nut with a new one and tighten to the specified torque. Install the wheel, lower the vehicle, and tighten the lug nuts to the torque.

After completing the installation process, the wheel and lug nuts should be installed. Then, the vehicle should be lowered and the lug nuts should be tightened to the specified torque.