Mercury 9L8Z-7821812-A Latch

You can Select Your Vehicle to check if 9L8Z-7821812-A fits your vehicle.

1. Raise the window. 2. Remove the door trim panel and watershield. 3. Inside the door, remove the door latch assembly screw and the door handle cover from the exterior of the door. 4. Carefully slide the door handle toward the rear of the vehicle. 5. Remove the rubber insulators and release the clip to position the interior door handle aside. 6. Remove the door latch screws and disconnect the door latch electrical connector. 7. Slide the door latch remote control assembly toward the front of the vehicle. 8. Remove the anti-theft guard and disconnect the exterior door handle actuating rod. 9. The installation process is the reverse of removal.

Once every 3,000 miles or every three months.

They should be lubricated with a thin coat of grease.

The process differs slightly, with additional steps for door handles, front door latch, lock cylinder, and rear door latch. However, the fundamental caution and attention to detail remain essential throughout the procedure.