Mercury 5F9Z-11582-BA Lock Assembly - Steering

You can Select Your Vehicle to check if 5F9Z-11582-BA fits your vehicle.

Remove the ' minus' end of the cable from the battery. Disconnect lower steering column cover. To unlock the reduction gears from the lock cylinder housing, press on the two release tab and pull the ignition switch out. Pull out the electrical connector by operating the release tab from the ignition switch. It is the process where by the components that had been assembled are disassembled. Pull out the Passive Anti-Theft System transceiver by pulling the head of the screw backward on the retaining tabs located in the lugs on the lock cylinder housing. Depress the lock button on the lower left of the Ignition Lock Cylinder and insert the ignition key into the Ignition Lock Cylinder. By rotating the ignition key you will bring the ignition to the RUN position. To disarm the Ignition Lock Cylinder, push the safety flat blade into the hole that is on the bottom of the Ignition Lock Cylinder, this will release the retaining tab and pull out the lock cylinder. Removal on the other hand is just the opposite of installation.